Altitude Converter screenshot

Altitude Converter

Convert an altitude between metres and feet with the exact 3.280839895 factor.

Privacy First
0 Runs
Updated 2026-11-06
No upload
Runs in this tab
No signup

One metre is exactly 3.280839895 feet, derived from the 25.4 mm inch and the twelve-inch foot. Enter a value and its unit and the page prints the other unit, with the factor stated underneath.

The altitude must be above 0 in either unit, so a zero is refused as a conversion that teaches nothing. Nothing is looked up: the page holds no elevation database and cannot tell you the height of a place.

One multiplication by a constant is the whole computation, so the answer never changes between reloads.

Metres and feet are converted with the exact factor 1 m = 3.280839895 ft, taken from 1 in = 25.4 mm and 1 ft = 12 in, so converting and converting back returns the number you started with.

The page converts a height, so an altitude of zero or below is refused: a zero is more often a missed field than a sea-level reading, and the message says so.

How to use it

Enter the altitude and pick the unit it is in (m or ft), then press Run. Two or three lines come back: the value you entered, the other unit's equivalent and the exact factor.

The arithmetic

Metres to feet multiplies by 3.280839895; feet to metres divides by the same number. The factor is printed so a hand check is possible, and both directions use one constant rather than two rounded ones.

What to Expect

Best for

  • Reading a mountain height or a cabin altitude in the unit your source does not use.

What this tool keeps

  • The entered altitude and its exact equivalent in the other unit.

Sample input

1500 m.

Sample output

Altitude = 1500 m = 4921.2598 ft 1 m = 3.280839895 ft exactly

Frequently asked questions

Are the figures exact?

The factor is exact by definition, but the printed result is trimmed to four decimals. Re-entering a printed figure can therefore differ in the last digit, which is a display limit and not a conversion error.

Why is a zero altitude refused?

The page is for converting a height, and a zero converts to zero in both units. It usually means a field was missed, so the page asks for a value above zero.

Does it handle flight levels?

No. Only metres and feet: a flight level is a pressure altitude in hundreds of feet and would need a pressure setting this page does not model.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.