Heart Rate Monitor
Turn a counted pulse and a stopwatch window into beats per minute and the beat interval.
A pulse counted by hand
Count the beats you feel and time the window you counted over. The page multiplies the beats by 60 and divides by the seconds for beats per minute, then divides 60000 by that rate for the interval between beats in milliseconds. Thirty beats in twenty seconds is 90 bpm with a beat every 667 milliseconds.
This is arithmetic on your own reading, not a monitor. The page runs no clock and reads no sensor, so a short window magnifies any miscount, and a pulse taken sitting differs from one taken standing. It does not detect arrhythmia and it is not a medical reading. A beat count of zero or a window of zero seconds is refused, because neither yields a rate.
The conversion happens in this tab from the numbers you type. No reading is uploaded or logged, and the same pair always prints the same rate and interval.
A pulse counted by hand, converted to beats per minute: beats × 60 ÷ seconds. Thirty beats in twenty seconds reads 90 bpm, and the second line gives the beat interval in milliseconds, which is the figure to watch when the rate is irregular. The page runs no clock — the window is whatever you timed, and it does not start, stop or average anything for you. A short window magnifies a miscount: one beat either way in fifteen seconds is four beats per minute. Beats and seconds must both be above zero, and the page makes no claim about what a rate means.
Pulse in bpm from beats × 60 ÷ seconds, with the beat interval in milliseconds.
How to use it
Find a pulse, count beats for a measured window, then enter the count and the seconds and press Run. The output is beats per minute plus the interval between beats. Counting for thirty seconds and doubling the count is the usual shortcut, but entering the real count and the real window here gives the same arithmetic without the doubling step.
The arithmetic
Beats divided by seconds gives beats per second, and multiplying by sixty converts to the per-minute convention. The interval is sixty thousand milliseconds divided by the rate, so the two printed figures are the same number in two units. There is no smoothing: an irregular rhythm produces one average, and the interval shown is the average gap rather than any single one.
Where it stops
Both inputs must be above zero. The figure is a sample of the window you measured, so a rate that changes during the count is flattened, and a very short window is noisy. The page reports a number and nothing else — it does not interpret the rate, and a pulse reading is not a diagnosis.
What to Expect
Best for
- Converting a hand-counted pulse into beats per minute.
- Getting the beat interval without a second calculation.
What this tool keeps
- Your count and window are used in the tab and never sent; there is no stored reading.
Sample input
30 beats in 20 s
Sample output
90 bpm 30 beats in 20 s — one beat every 667 ms.
Frequently asked questions
How do I use the heart rate monitor?
Count beats over a timed window, enter the beats and the seconds, then press Run. The page prints the rate in bpm and the average interval between beats.
Is anything uploaded?
No. The arithmetic is done in this tab; no request leaves the browser, nothing is stored, and the page keeps working offline.
What are its limits?
Both figures must be above zero, and the accuracy is limited by the window — a miscount in fifteen seconds is four bpm. It reports the sample you took, not a continuous reading, and it does not interpret the number.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.