Board Foot Calculator
Board feet from thickness, width and length in inches and feet, with waste included.
Board feet per piece is thickness in inches times width in inches times length in feet, divided by 12. The page multiplies by the piece count and adds your waste percentage, in imperial board measure.
Any zero or negative dimension is refused by the field it was typed in, and a waste percentage above 50 is refused as outside the range the page applies. The waste figure appears on the answer line.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
Board feet per piece is thickness in inches × width in inches × length in feet ÷ 12, multiplied by the piece count and your waste percentage: ten 2 × 6 × 8 ft boards at 10 percent read 80 board feet and an order of 88. The arithmetic is imperial board measure throughout, and the waste figure is printed on the answer line rather than folded into a constant.
Imperial board feet, with your waste percentage on the answer line.
An ordering estimate, not a structural specification.
How to use it
Enter thickness and width in inches, length in feet and the number of pieces, then set a waste percentage and press Run. The page prints board feet per piece, the piece total and the total with waste.
Waste and units
Board measure is an imperial convention: inches for the cross-section, feet for the length, twelfths to convert cubic inches into board feet. The waste percentage you type multiplies the finished count, and a figure above 50 is refused because it would be an allowance no cutting plan supports.
Where the page stops
Any zero or negative dimension is refused by the field it was typed in.
What to Expect
Best for
- Ordering rough or dressed lumber by board measure.
- Seeing the piece count and the waste allowance separately.
What this tool keeps
- The per-piece figure, the count and the waste percentage all print, so the order can be re-derived.
What may need cleanup
- Nothing: the three lines are the whole output.
Sample input
2 in × 6 in × 8 ft, 10 pieces, 10 percent waste
Sample output
Per piece: 2 × 6 × 8 ÷ 12 = 8 board feet 10 pieces: 80 board feet With 10 percent waste: 88 board feet
Frequently asked questions
How do I calculate board feet?
Enter thickness and width in inches, length in feet and the piece count, set a waste percentage and press Run. The page multiplies the cross-section by the length, divides by 12 and adds your waste.
Is anything uploaded?
No. The arithmetic runs in this tab with JavaScript: no request is made, nothing is stored, and no account is involved.
What waste percentages does it accept?
Anything up to 50 percent. Above that the page refuses the figure, because an allowance that large is not a cutting allowance any more.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.