Brick & Mortar Calculator
Bricks and mortar for a single-skin wall at 59.259 bricks per square metre, waste included.
A 215 x 65 mm brick with a 10 mm joint covers 0.225 x 0.075 m, which is 59.259 bricks per square metre. Mortar is taken at 0.03 cubic metres per square metre of wall, in metric units.
A zero or negative wall length or height is refused by name, because the area would be zero. The waste percentage you type multiplies both the brick count and the mortar volume, and both are printed.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
A 215 × 65 mm brick with a 10 mm joint covers 0.225 × 0.075 m, which is 59.259 bricks per square metre, and mortar is taken at 0.03 cubic metres per square metre of single-skin wall. Both the brick count and the mortar volume are multiplied by your waste percentage and printed, so a 12 m² wall at 5 percent reads 747 bricks and 0.378 m³. Units are metric throughout.
Metric bricks and mortar for a single-skin wall, at 59.259 bricks/m² plus waste.
An ordering estimate, not a structural specification.
How to use it
Enter wall length and height in metres and a waste percentage, then press Run. The page prints the wall area, the brick count before and after waste, and the mortar volume before and after waste.
Waste and units
59.259 is 1 ÷ 0.016875, the face a 215 × 65 mm brick covers once a 10 mm joint is added on two sides; the joint is why the count is not simply the brick face. Mortar at 0.03 m³ per square metre is a per-area allowance for a single skin, and both figures take the same waste percentage because both are ordered together.
Where the page stops
A zero or negative wall length or height is refused by name, because the area would be zero. The page sizes one skin: a cavity or a thicker leaf doubles the brick count, and piers, openings and reinforcement are outside what it can see.
What to Expect
Best for
- Ordering bricks and mortar for a single-skin metric wall.
- Seeing the brick count and mortar volume before waste and after.
What this tool keeps
- Both pre-waste and post-waste figures print, so the allowance can be checked separately.
What may need cleanup
- Nothing: the four figures are the whole output.
Sample input
wall 5 m × 2.4 m, 5 percent waste
Sample output
Area: 12 m² Bricks: 12 × 59.259 = 711.1 → 747 with 5 percent Mortar: 12 × 0.03 = 0.36 m³ → 0.378 m³ with 5 percent
Frequently asked questions
How many bricks and how much mortar?
Enter wall length and height in metres and a waste percentage, then press Run. The page prints the area, the brick count and the mortar volume, each with and without waste.
Is anything uploaded?
No. The multiplication happens in this tab, so nothing is posted, nothing is retained and no account is needed.
Which units does it use?
Metric: metres for the wall, bricks per square metre and cubic metres for mortar. A wall entered in feet lands outside the range and prints a figure that is visibly wrong.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.