Gravel Volume Calculator
Gravel volume and tonnage for an area and layer depth, in metric units with waste included.
Volume is area in square metres times layer depth in metres, multiplied by one plus your waste percentage. Mass is that volume at 1600 kg per cubic metre of loose gravel, in metric units.
A zero or negative area or depth is refused by the field it was typed in, and a waste percentage above 50 is refused. The waste percentage and the density used are both printed.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
Volume is area in square metres × layer depth in metres, multiplied by one plus your waste percentage, and mass is that volume at 1600 kg per cubic metre of loose gravel. Twenty square metres at 100 mm with 10 percent waste therefore reads 2.2 m³ and 3520 kg, in metric units.
Metric gravel volume and tonnage at 1600 kg/m³, waste included.
An ordering estimate, not a structural specification.
How to use it
Enter area in square metres, layer depth in metres and a waste percentage, then press Run. The page prints the volume, the volume with waste, and the tonnage at the density it names.
Waste and units
Area times depth gives cubic metres with no conversion, and 1600 kg/m³ is the loose bulk density the page uses — compacted gravel is denser, so the page states which one it applied. The waste percentage scales the volume, and the tonnage follows the scaled figure, so the two lines agree.
Where the page stops
A zero or negative area or depth is refused by the field it was typed in, and a waste percentage above 50 is refused. Real bulk density varies with the aggregate and with moisture, so the tonnage is a purchase figure rather than a weighing; compaction and sub-base preparation are outside the page.
What to Expect
Best for
- Ordering gravel by volume or by the tonne.
- Seeing the density the tonnage was computed at.
What this tool keeps
- The density and the waste percentage print, so the tonnage can be reworked for a different supplier figure.
What may need cleanup
- Nothing: the volume and the tonnage are the whole output.
Sample input
20 m², 0.1 m deep, 10 percent waste
Sample output
Volume: 20 × 0.1 = 2 m³ With 10 percent waste: 2.2 m³ Mass at 1600 kg/m³: 3520 kg (3.52 t)
Frequently asked questions
How much gravel do I need?
Enter area in square metres, depth in metres and a waste percentage, then press Run. The page prints cubic metres and the tonnage at 1600 kg/m³.
Is anything uploaded?
No. Both the volume and the mass are computed in this tab: nothing is posted and nothing is retained.
What density does it use?
1600 kg per cubic metre of loose gravel, printed with the answer because compacted gravel is denser and would give a different tonnage.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.