Rafter Length Calculator
Rafter length from rise, run and overhang by Pythagoras, with waste included.
The sloped length is the square root of rise squared plus run squared, from Pythagoras. The page adds the overhang you enter and multiplies by one plus your waste percentage, in metric units.
A zero or negative rise or run is refused by name, and a negative overhang is refused. The page notes that no birdsmouth is deducted, so the figure is an ordering length rather than a cut list.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
The sloped length is the square root of rise squared plus run squared, from Pythagoras, with the overhang you enter added and the total multiplied by one plus your waste percentage. A 2.5 m rise over a 4 m run with a 0.5 m overhang at 10 percent therefore reads 5.74 m, in metric units.
Metric rafter length by Pythagoras, plus overhang and waste.
An ordering estimate, not a structural specification.
How to use it
Enter rise and run in metres, the overhang in metres and a waste percentage, then press Run. The page prints the sloped length, the overhang addition, the total with waste and the rise-over-run ratio.
Waste and units
Rise and run are the two legs of a right triangle, so the rafter is the hypotenuse and no trigonometry is needed. The overhang is added once, because it extends the rafter rather than scaling it, and the waste percentage then covers cutting and the occasional bad board.
Where the page stops
A zero or negative rise or run is refused by name, and a negative overhang is refused. No birdsmouth is deducted, so the figure is an ordering length rather than a cut list; the page states that, because a plumb cut and a seat cut change the board length a carpenter actually cuts.
What to Expect
Best for
- Ordering rafter stock from a rise, run and overhang.
- Seeing the sloped length behind a roof geometry.
What this tool keeps
- The sloped length and the overhang addition both print, so the total can be rebuilt.
What may need cleanup
- Nothing: the length and the addition are the whole output.
Sample input
rise 2.5 m, run 4 m, overhang 0.5 m, 10 percent waste
Sample output
Sloped length: √(2.5² + 4²) = 4.717 m With overhang: 5.217 m With 10 percent waste: 5.74 m
Frequently asked questions
How long are the rafters?
Enter rise, run and overhang in metres and a waste percentage, then press Run. The page applies Pythagoras, adds the overhang and applies the waste.
Is anything uploaded?
No. The square root is taken in this tab: nothing is posted, nothing is retained, no account is involved.
Why is no birdsmouth deducted?
A birdsmouth depends on the seat cut and the wall plate, which the page does not know, so it prints an ordering length and says that a cut list needs the deduction.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.